|
|
|
|
|
|
HomeAutoNeon LightingBulbsTri Bar Head Light W / Turn Signal W/ Bulb Neon-Lighting Bulbs |
|
|  |
| Customer Reviews: | | Average Customer Review: ( 1 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
2 of 2 found the following review helpful:
They're ok, but the tri-bar assembly is cheap Dec 27, 2010
By Tharkis
I purchased a pair of these headlights for a project. When they arrived, the first thing that I wanted to do was to change the color-dots to match my car. Unfortunately this is much easier said than done. The color dot is held in the center of the tri-bar assembly. The dots themselves have a 3/8 inch allen-wrench hole in the back of them, and they twist lock into place with a spring to the center of the tri-bar assembly. This is all fine, except the metal the tri-bar is made from is very thin and bendable. I ended up spending over an hour per light to change the dot, and had to use needle nose pliers, locking forceps, and a various dental picks and hooks to re-bend the bars back into shape after getting first the factory installed color dots removed. The lights look nice, but the construction quality is only fair, not very good. The tri-bars really should have been made of stronger material, and the bars should have been held in place firmly, brazed or welded, not just glued in with silicon caulking. I'm not sure if I would recommend these to a friend based on that.
Also of note, the wiring and molding for the wiring for the built in turn signal sticks out quite a bit from the rear of the bulb, and far off center, so that in both vehicles that I have with 7" round lights, the rear headlight mounts will need to be modified in order to use these headlights. They could have had the wiring much closer to center, or the molding for the wiring much shorter and have had it just as good but fitting standard 7" headlight mounts much better.
|
| | |
|
|
|
|
|
