|
|
|
|
| Folding Knives Collectables |
|
|
HomeSportsKnivesFolding Knives CollectablesNo Load Adjustable Pulse Flasher Covers Turn Signal |
|
|  |
| Customer Reviews: | | Average Customer Review: ( 3 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
1 of 1 found the following review helpful:
 It worked poorly, while it lasted May 05, 2011
By Customer
I must say I am very disappointed. I would give this product 0 stars if it was possible. Too much hype for an expensive product that doesn't deliver.
As an electrician, I can share the following insight.
"Great for led tail lights" - I believe this should read "great ONLY for LED tail lights". Because with my regular lightbulbs, it burned out within a few flashes. The flasher became hot and won't work anymore. It came with no electrical specifications (nor did I find any on Amazon) which should have been my first warning. EVERY electrical device must come with specifications. Especially maximum current load. How many lightbulbs can this flasher operate? Didn't say. It turns out that 3 are too many (1 in the front, 2 in the tail lights). So much for stock replacement. So even though this flasher is designed to replace the units in many GM vehicles, it does not work in GM vehicles.
So I give this product a big thumbs down. The Chinese need to learn how to steal electronic designs better, they still have miles to go.
I am shipping this joke back and I hope I get a full refund.
Terrible product May 30, 2011
By TGO
It lived all of 30 seconds! Granted, it was great for that 30 seconds but.....
I installed it, turned on my left turn signal & went to check it. Looked good, but still too fast for my car. No problem. I go back in the car, adjust it fully counter clockwise assuming that direction is for slower. Flip the left turn switch again, go to the back of my car to look.....NOTHING! I tried several times adjusting it trying to get it working (and the unit was HOT), but nothing. It had burned up.
Don't buy this unless you want to waste your time & money.
 Perfect LED/sequencial Fasher May 03, 2009
By Edward A. Lizotte
"BRD_PREY"
This flasher exceeded the products statements. Not only is it adjustable for flash rate but also for voltage rise and fall. This flasher allows you to slow the flash rate down with LEDs. I have 100% LEDs and went through 4 other brands of electronic flashers. They all had various levels of effectiveness but none of them were slow enough for my sequential taillights to look like I wanted them. Its expensive but works. If I add up the flashers I bought though its cheaper!
|
| | |
|
* Estimated shipping rate for US 48 states. Final rate calculated at checkout. |
|
|
|
